This post will focus on the manual backup of Junos configuration files. Many networks will use a Network Management System (NMS) or a scripting solution like Ansible or Rancid to perform daily backups of network devices. You can also use the archival command to have Junos automatically backup the configuration every time a commit is […]
Junos Saving, Exporting, And Restoring The Configuration Read More »
When we advertise a BGP route to an eBGP neighbor, it is common to remove any private AS numbers that are in the AS path. One reason to do this is to hide any complexity within our network so our eBGP peers only see our public AS number in the path. On Junos, this can
Junos BGP Remove Private AS Read More »
On Junos, we can limit the number of prefixes, or routes, that a BGP neighbor can advertise to us. We can choose what to do when we receive too many routes. We can start logging messages or we can tear down the BGP session. Sessions can be torn down for a set amount of time
Junos Setting BGP Prefix Limits Read More »
On Junos, only active BGP routes are advertised to peers. If we want to change this behavior we need to set the advertise-inactive BGP knob. The following example walks through this process. Lab Environment The lab is set up as per the below diagram. Lab Baseline On vMX-2 we have four BGP routes being learned
Junos Advertising Inactive BGP Routes Read More »
Local Preference is used to choose the best path out of our network. It is typically applied to inbound route advertisements to influence how traffic leaves our network. The local preference attribute is advertised over iBGP to other routers within our AS. On Junos, local preference is configured using a routing policy. We will see
Junos BGP Local Preference Example Read More »
AS prepending is used to artificially increase the length of the AS Path attribute. It is typically applied to outbound route advertisements to influence how traffic enters our network. On Junos, AS Prepending is configured using a routing policy. We will see how to do this in the following examples. Lab Environment The lab is
Junos BGP AS Prepending Example Read More »
It can be difficult to troubleshoot the establishment of BGP sessions. Sometimes the issue is obvious, but other times it can be a vague and frustrating process. In this post, we will run through some of the tools available, the BGP Finite State Machine (FSM), and a general approach for troubleshooting BGP establishment. BGP Troubleshooting
Troubleshooting BGP Establishment Read More »
In this post, we will look at configuring VLANs, trunk ports, and IRB (or VLAN) interfaces on Junos devices. The IRB interfaces are layer 3 interfaces for VLANs and are the same as Cisco VLAN or SVI interfaces. The commands here are based on the Enhanced Layer 2 Software (ELS) style of CLI which is
Junos VLAN Configuration Read More »